0

Main spar in main wing – part 1

I cutted a slot of 3mm wide for the main spar.

20121222-160908.jpg

Now i will apply baking paper on the bottom and secure it with packong tape which also will keep the gap tight.

20121222-161510.jpg

Now the baking paper is in place i will use construction glue to fill the gap.

20121222-162010.jpg

Be sure to apply enough glue on the innerside of the depron so the wooden spar is well glued to the depron.

20121222-162535.jpg

The spar is now in place and i added some weights to keep the wing flat.

20121222-162859.jpg

As you can see the spar is not complete covered with glue. This is not a problem because the glue will expand and it will be tight on the bottom. When the glue is hardened i will finish of the top with hotglue…

Leave a Reply

Your email address will not be published.