FPV Groundstation
Build groundstation for FPV 1.3 Ghz RX with cloverleaf Powered by 3s lipo Video splitter / booster LCD screen – sun protection Measure power needed
FPV cockpit v2 is almost ready
What is left? Mount camera Secure wires Finish it with Depron so it is solide and easy to grab when removing or placing the battery. Without worrying about to break something.
Ailerons are fitted
Cutted out the ailerons, made a 45 degree bevel on the aileron ans also a little bit on the wing side. Then putted it together with Tesa extra strong tape. Forgot to make pictures but this is no rocket science.… Continue Reading
Side spars in main wing
For the sidespars i also use 4mm round plywood. I made a gutter of 3mm so it is a tight fit. Also filled it with construction glue and inserted the wooden spars. So mow the main wing has all the… Continue Reading
Main spar in main wing – part 2
I removed the baking paper from the bottom and that is workin so easy… The glue is spread a bit but i can sand that away if it anoys me. And on the top you can see the spar is… Continue Reading
Main spar in main wing – part 1
I cutted a slot of 3mm wide for the main spar. Now i will apply baking paper on the bottom and secure it with packong tape which also will keep the gap tight. Now the baking paper is in place… Continue Reading
Cutted te main wing
Cutted the main wing from 6mm Depron. And i will use 4mm round plywood instead of Carbon. Why? Because i could not get carbon spars within 24h and you can buy this almost everywhere. Costs: 1 meter, 4mm diameter. 0,65… Continue Reading
Buzzard is almost alive !
The Buzzard is coming alive. Yesterday i created the V-Tail rods from 1.2mm Welding wire.